FACE MASK VISOR SANITIZER
I have finished phase one and greeted the patient. We move now to phase two and get ready to operate.
I'm putting on the surgical mask. It's important to make a knot up here,
and then another knot by the neck.
This is to ensure that it's completely tight. It will then stay on much better.
I'm now putting on my eye shields.
If you experience fogging, tighten the face mask or lower your eye shields a bit.
Otherwise it can help to put on a strip/tape over here.
We move on to the visor.
Do not place it too high or too low, but quite at the center.
I am now ready to sanitize.
Take a generous amount. Same principle as during hand washing.
Be sure to sanitize well, including the fingers.
Do not forget your thumbs.
And even more sanitizer.
It should be obvious that one has sanitized by looking at the floor.
Over the elbows.
We can now finish up.
Allow time for it to fully dry. This process takes about three minutes.